Skip to main content

Set up the Hardware Kit

You must first set up the end zone kit for the system to function correctly. If you have not set up the end zone kit, stop and go back to the end zone setup.

  1. Connect the Extension Cord (G) to power.

  2. Power on Streaming Kit (H).

    Wait 2 minutes for the Streaming Kit (H) to fully power on before moving to camera setup.

  3. Power on your press box camera. Connect your camera to the Streaming Kit (H) via an HMDI Cord (not provided).

  4. Attach the Press Box Bridge (I) to the outside of your press box window.

    Face the Press Box Bridge (I) down toward the End Zone Bridge (F).

If your streaming kit looks different than the one in the steps above, follow the steps below instead.

  1. Connect the Extension Cord (G) to power.

  2. Check the LED lights on the Streaming Kit (H), they should be on.

  3. Power on your press box camera. Connect your camera to the Streaming Kit (H) via an HMDI Cord (not provided).

  4. Attach the Press Box Bridge (I) to the outside of your press box window.

    Face the Press Box Bridge (I) down toward the End Zone Bridge (F).